Cue keypadCUE-8 Bedienungsanleitung

CUE, a.s., K Nouzovu 6, 143 00 Praha 4, Czech Republic fax: +420 241 432 446www.cuesystem.commail: [email protected]: +420 241 091 240 Use

4. Addressing 4.1. Addressing buttons of keypadCUE-8 4.1.1. Addressing rules The ADDRESS of the buttons and LEDs of keypadCUE-8 can be set in the rang

4.1.2. Setting-up keypad buttons ADDRESS 1. Push the keypad button addressing switch on the rear side of keypadCUE-8 by small screwdriver or wire;

4.2. Addressing the built-in IR receiver in keypadCUE-8 4.2.1. Addressing rules It is possible to add an offset to a BUTTON_ID sent by the irCUE contr

The BUTTON_ID sent by irCUE Receiver 485 to the control unit is the BUTTON_ID sent by IR wireless control panel with an added OFFSET value. Button ID

5. Mounting keypadCUE-8 can be mounted into a standard European electrical wall box with spacing 60 mm between mounting screws. Steps: 1. Mount the

3. Place keypadCUE-8 onto the supporting panel as indicated by the arrows in the picture bellow. 4. To remove keypadCUE-8 with the activated locki

6. Connecting keypadCUE-8 is connected to the system by CUEwire. Pin connection of the CUEwire connector is described in the following picture.

7. Specifications and Mechanical Drawings Buttons layout...8 buttons Indication ...

8. Software and Firmware License END-USER NOTICE AND LICENSE AGREEMENT FROM CUE, a.s. NOTICE TO END-USER: CAREFULLY READ THE FOLLOWING LEGAL AGREEM

Notes User Manual keypadCUE-8 www.cuesystem.com Page 19 of 20

User Manual keypadCUE-8 UM037_01, 21.05.2008 Copyright © CUE, a.s., Praha, Czech Republic 1990 - 2008. All rights reserved. Specifications are subject

User Manual keypadCUE-8 www.cuesystem.com Page 20 of 20 Notes

Table of Contents 1. Introduction...

1. Introduction 1.1. Overview... Featuring a beautiful stainless steel architectural

2. Front Panel The front panel is equipped with 8 buttons and 8 indication LEDs - see picture. Button LEDs and their ON or OFF state are controlle

3. Button Labels 3.1. Button labels for keypadCUE-8-E keypadCUE-8-E uses the separate plastic stripe on the front panel for customized engraved lab

2. Clean and degrease the rear glossy part of engraved stripes by denatured alcohol. 3. Remove the release liner from the top part of keypadCUE-8

3.2. Button labels for keypadCUE-8-L For keypadCUE-8-L, two types of custom labels can be used. Paper labels can be used temporarily during trial oper

3. When changing the label, it is necessary to remove the transparent cover carefully. Use a small screwdriver to do this. Insert the screwdriver int